Installation Guide
Most standard faucets install tool-free in about a minute. Keep your old aerator in case you ever want to swap back.
- Turn the faucet off. Unscrew your existing aerator from the faucet tip (turn it toward you / counter-clockwise). Use a cloth for grip if it's tight.
- Check that the included gasket/washer is seated inside Flowvera.
- Hand-tighten Flowvera onto the faucet threads, clockwise, until snug. Do not over-tighten.
- Use the appropriate included adapter or washer if your faucet thread requires it.
- Run water and check the connection for drips. If it weeps, remove, reseat the gasket, and re-tighten — or add 1–2 wraps of plumber's tape to the threads.
- Rotate the head to test its full range of motion and select your flow mode.
Troubleshooting a leak: the most common cause is a misaligned gasket or too much/too little plumber's tape. Remove, reseat, and re-tighten by hand.